You may remember a few years ago I made this gingerbread house for a Daring Bakers Challenge  – based on an image I found on the internet. I had to design the house from scratch, and there were quite a few difficulties.
Over the years I have had many requests for the pattern, although it had been pushed away in a drawer, all cut up. I finally got a chance to trace it out nicely and have attached it to this post for you to use. Apologies to all those who have waited and missed out on making it in previous years.
1. when printing – Do not scale to fit. (make sure there is no scaling)
2. Check the measurements with a ruler before cutting (the roof and walls seem to get cut off a bit – although as these are straight lines you can draw this in).
3. Make a demo house and check all the sizes match up and that the house and roof all work together – adjust if necessary.
4. Please see my original post  for extra info and any troubles I had with the construction.
Click below link for a copy of the template in pdf.
(please note: the above link does not show some of the right hand measurement on the front of the house (which can be seen in the images below) – as it had to be cut off to allow printing margins)